ANALYSIS STUDY ANALYSIS OF THE TRIBOLOGICAL CHARACTERISTICS OF A POROUS IRON BASED ANTIFRICTION ALLOY

Authors

  • Bekzod Nabiev Nematjonovich Doctor of Philosophy, docent Andijan State Technical Institute

Keywords:

babbit, pyrite, antifriction alloy, coefficient of friction, wear rate, materials, friction, tribology, iron-based alloys.

Abstract

This study presents a comparative investigation of the tribological properties of a pyrite-containing iron-based antifriction alloy under self-lubricating conditions, relative to a conventional iron–graphite antifriction alloy. The effects of pyrite addition on friction coefficient, wear rate, and surface morphology of the friction pair were systematically evaluated under varying loads and sliding speeds. Microstructural characterization using metallography and scanning electron microscopy revealed correlations between pyrite content, phase composition, porosity, and tribological performance. Results indicate that pyrite promotes the formation of secondary protective layers within the friction zone, significantly reducing both friction and wear. These findings provide a scientific basis for optimizing the composition and processing of iron-based antifriction alloys to enhance their tribological efficiency and operational durability. The study contributes to the development of advanced self-lubricating materials for high-performance engineering applications.

References

Федорченко И.М., Францевич И.Н., Радомысельский И.Д. и др. Порошковая металлургия. Материалы, технология, свойства, области применения. – Киев: Наукова думка, 1985 г. – 624 cт.

F.R.Norkhudjayev, A.A.Mukhamedov, B.N.Nabiyev, M.M.Khodjimukhamedova, Teshaboyev Abduvakhob Marifovich MECHANICAL CHARACTERISTICS OF POWDERED ALUMINUM BRONZE OBTAINED FROM METALLURGICAL WASTE. International Journal of Mechatronics and Applied Mechanics, 2022, Issue 11. Page: 95-97.

F.R.Norkhudjayev, A.A.Mukhamedov, B.N.Nabiyev, M.M.Khodjimukhamedova, R.F.Norkhudjayeva INFLUENCE OF DOUBLE PHASE RECRYSTALLIZATION ON STRUCTURE FORMATION OF CARBON AND TOOL STEELS. International Journal of Mechatronics and Applied Mechanics. International Journal of Mechatronics and Applied Mechanics, 2021, Issue 10, Vol. I. Page: 168-174.

Published

2026-01-30

Issue

Section

Articles